Best surge protection device for solar panels | LKX-T1T2-DC
| Specification | LKX-1200-6.25 | |
| SPD classification according to EN61643-31 / IEC61643-31 | Type 1 + Type 2 / Class I + Class II | |
| Max. continuous operating d.c. voltage | Ucpv | 1200V |
| Lightning impulse current (10/350μs) | Iimp | 6.25kA |
| Nominal discharge current (8/20μs) | In | 20kA |
| Max. discharge current (8/20μs) | Imax | 40kA |
| Residucal current | Ipe(DC) | ＜0.02mA |
| Specific energy | W/R | 9.76kJ/Ω |
| Voltage protection level [(DC+/DC-)→PE] | Up | ≤4.5kV |
| Short-circuit current rating | Iscpv | 10kA |
| Response time | tA | ≤25ns |
| Operating temperature range | Tu | -40℃-80℃ |
| Operating state / fault indication | green / red | |
| Cross-section area (Min.) | 4mm² | |
| Cross-section area (Max.) | 35mm² | |
| For mounting on | 35mm Din rail | |
| Enclosure material | Thermoplastic UL94-V0 | |
| Degree of protection | IP20 | |
| Order code | LKX12003625 | |
| Order code (with remote signal) | LKX12003625-1 | |
Features:
Thermal disconnect device for each individual connector
Normal discharge current (8/20us) In: 20kA
Mechanical status indication for the individual surge protective device module
High energy varistors.
With or without floating remote indication contact
Application:
LKX Surge protective device, protect against lightning surge voltages in solar system (photovoltaic power supply system).
Used for surge protection of electrical components in any other DC circuit.
These units must be installed in parallel on the DC networks to be protected and provide common and different modes protection.
It is suitable for surge protection of DC power supply line equipment of solar power generation system.
Installation and maintenance：
Installed in parallel at the interface of LPZ1 zone and subsequent zones: power controller, power converter, etc.
When the surge arrester is installed under the required conditions, it does not require long-term maintenance, but only routine maintenance. If the color of the visible alarm window changes to red (fault) during use, it indicates that the surge protector is damaged and needs to be repaired or replaced.